Stainless cap with spark screen, measured to your flue and installed for $155 to $635, exact figure given before fitting. In Encino you get the price in writing first, with any extra repairs split into what is urgent and what can wait.
Tell us about the chimney at your Encino house and we will come back with a starting figure or a time to look.
Encino houses often have two or three fireplaces and sometimes an outdoor fire feature, which makes a full set of repairs expensive at once. We write each fireplace up on its own lines, so you can do the one you use most this year and the guest room fireplace next year. For chimney cap installation in Encino, Lawson & Son Chimney Care writes the price down before anything starts, and splits any extra findings into what is urgent and what can wait.
Location
Encino, CA
Job
Chimney Cap Installation
ZIPs
91316, 91436
Part of town
the large lots between the Sepulveda Basin and the hills south of Ventura Boulevard
Encino houses often have two or three fireplaces and sometimes an outdoor fire feature, which makes a full set of repairs expensive at once. We write each fireplace up on its own lines, so you can do the one you use most this year and the guest room fireplace next year.
Large chimneys on big ranch houses carry more brick above the roof, and that is where valley heat and winter rain do their work. A crown recast with a drip edge often solves the water problem without repointing the whole stack.
Close by
These neighbors share the same booking days and the same written-estimate process. On a border street? Call or send the address and we will confirm.
Encino houses often have two or three fireplaces and sometimes an outdoor fire feature, which makes a full set of repairs expensive at once. We write each fireplace up on its own lines, so you can do the one you use most this year and the guest room fireplace next year. Knowing that ahead of time keeps the estimate close to the final bill, because we arrive with the right ladders, parts and expectations.
Wear that is not letting water in or heat through can usually wait a season or two. Cracked flue tiles, loose brick and a missing spark screen cannot. Every written list we leave in Encino marks each item one way or the other.
From Encino we also book Tarzana, Sherman Oaks, and Lake Balboa, and the regular ZIP list runs 91316 and 91436. Border street? One call settles it.
Same address, different job. Each of these is priced the same way: set figure or written estimate.
Flue brushed top to bottom, smoke shelf cleared, hearth vacuumed, from $210 with the figure confirmed before any brush goes up.
View local serviceLevel 1 visual check for $52, with every finding labelled fix now, plan this year, or watch, in a short written list.
View local serviceLeaks, cracked crowns and broken flue tiles traced to the source, then quoted in writing with more than one option where there is one.
View local serviceFirebox, damper, smoke chamber, hearth and mantel clearances checked, with findings ranked and priced where a price is possible.
View local serviceFirebrick, refractory panels, dampers and smoke chambers repaired, with the quick fix and the lasting fix priced side by side.
View local serviceFull video scan of the flue for $320, used for home sales and after quakes, storms or a chimney fire.
View local serviceWater test first to prove the leak is the flashing, then reseal, partial or full replacement priced in writing.
View local serviceBrick and mortar mapped in sections, each priced separately, with sound courses left alone and marked for a later check.
View local servicePartial or full-height rebuilds quoted next to the repair route, with the cost split into demolition, masonry, liner, crown and permit.
View local serviceFirebox ash, smoke stains, glass doors and hearth cleaned, with worn gaskets or panels written down rather than sold on the spot.
View local serviceBurner, pilot, logs, glass and vent cap serviced once a year, carbon monoxide tested, worn parts priced before they are swapped.
View local servicePilot, thermocouple, valve and igniter faults found with a meter, then repair and replacement prices put side by side.
View local serviceRefacing, gas conversion or a full fireplace wall, priced in stages so you can stop at the stage that fits your budget.
View local serviceGas inserts installed in an existing fireplace for $2,650 to $5,300 with liner and venting; wood and electric quoted after a visit.
View local serviceIgniters, augers, blowers and boards tested with a meter, and nothing ordered until you have seen the price and the wait.
View local serviceGaskets, firebrick, baffles, glass and stovepipe checked, each worn part priced, and safety items marked before the next fire.
View local serviceVented or ventless log sets sized to the firebox, with the gas line and damper clamp priced in writing before installation.
View local serviceThe price drivers shift from city to city. Each page lists what we tend to find there and how that shows up on the estimate.
the ranch streets and canyon lots of the far west Valley
Most Woodland Hills chimneys we price are single brick stacks on ranch houses that have had a roof or two replaced around them. The usual list is a tired crown, flashing held on by old sealant, and joints worn on the upper courses. Very few need everything at once, so the estimate is often split across two seasons.
View nearby citythe post-war blocks of the Rancho, Magnolia Park and the foothill streets
Many Burbank homes still have their original brick chimney or an early factory-built fireplace. For the brick ones, the choice is usually between repointing the top few courses and rebuilding above the roofline, and we price both. For older factory-built units, we check that parts are still made before quoting a repair.
View nearby citythe flat, gridded blocks between Topanga Canyon Boulevard and the Chatsworth hills
Canoga Park is mostly one-story tract and ranch houses with modest brick chimneys, which keeps access simple and repairs moderate in cost. The common jobs are a new cap, crown work and repointing the top few courses. Many owners here go to a gas insert instead of rebuilding an old firebox, and we price both.
View nearby citythe blocks north of Ventura Boulevard and the hills toward Mulholland
Sherman Oaks mixes brick chimneys on older ranch homes with factory-built fireplaces in condos and newer houses. The two need different repairs and different parts, so we identify the type before quoting. Hillside chimneys are often tall and exposed, and the estimate separates the work from the ladder or staging needed to reach it.
View nearby citythe flats below Ventura Boulevard and the canyon streets above it
Studio City has two kinds of chimney job. On the flats, it is usually a one-story brick chimney with worn joints that can be repointed in a day. Up in the hills, access sets the price: a steep roof or a tall stack on a downhill lot can cost more to reach than to repair, and the written estimate shows that split.
View nearby cityYes. Lawson & Son Chimney Care confirms set prices before starting and quotes any repair on paper first, for Encino and for nearby Tarzana and Sherman Oaks.
The booked work covers installed for $155 to $635; stainless body with spark screen; single-flue or crown-mount choice. Anything else we spot is written up as a separate line with its own price, and is only done if you ask.
Wear that is not letting in water or heat can usually wait a season. Safety items cannot. Our written list for homes in 91316, 91436 marks each finding as fix now, plan for, or watch.
